FROM THERMAL ENGINES TO FLUID–MECHANICAL ENERGY CONVERSION

Why TEAS®–L-CPC Explores a New Energy Paradigm

For more than a century, a fundamental component of electricity generation has relied on the conversion of heat into mechanical work:

Thermal energy → mechanical work → electricity

Internal combustion engines, gas turbines, steam turbines, and combined cycles employ different architectures, but share the same fundamental energy-conversion principle.

TEAS®–L-CPC starts from a different question:

If an energy phenomenon directly provides a component that can be converted into mechanical work, is it necessary to first convert it into heat?

THE LIMITATIONS OF THERMAL ENERGY CONVERSION

For an ideal heat engine operating between a hot reservoir at ThT_h and a cold reservoir at TcT_c, the maximum theoretical efficiency is given by the Carnot limit:

η₍Carnot₎ = 1 − T꜀ / Tₕ

No real heat engine can exceed this limit, and its actual efficiency is further reduced by process irreversibilities and energy losses.

The Carnot limit therefore applies to the conversion of heat into mechanical work through a heat engine.

A different possibility therefore emerges: rather than focusing solely on improving the heat engine, investigate whether an alternative conversion architecture can be employed.

WHY L-CPC EMERGES

If the TEAS® process indeed generates an impulsive, fluid-mechanical component, the phenomenon can be investigated through a conversion architecture specifically designed to harness it.

Rather than adapting the phenomenon to a heat engine, design the machine around the phenomenon itself.

L-CPC emerges from this approach as a fluid-mechanical energy conversion system, coupled to subsequent electricity generation.

A DIFFERENT CONVERSION ARCHITECTURE

TEAS® represents the process.

The impulsive phenomenon represents the component to be harnessed.

L-CPC represents the fluid-mechanical conversion architecture.

The generator performs the electrical energy conversion.

The potential innovation therefore lies not merely in the use of water, but in the possibility of reducing the number of energy-conversion stages between the phenomenon and electricity, avoiding, where feasible, the intermediate step of a thermodynamic cycle.

WHAT COULD CHANGE

If the principle is experimentally validated, this architecture could enable the exploration of:

  • Conversion without an intermediate thermodynamic cycle;

  • Reduction in the number of conversion stages and associated energy dissipation;

  • Recirculation of the working fluid;

  • Modular and potentially scalable architectures;

  • A conversion architecture specifically designed to harness the impulsive nature of the phenomenon.

THE POTENTIAL PARADIGM SHIFT

Thermal technologies have played a fundamental role in industrial development.

TEAS®–L-CPC explores a different approach:

From heat to the underlying phenomenon
From the thermodynamic cycle to fluid-mechanical conversion
From a machine adapted to the energy source to a machine designed around the phenomenon

THE VALIDATION

TEAS®–L-CPC is a research and development project.

The phenomenon, the energy that can actually be converted, and the performance of the architecture are subject to experimental validation.

The comparison must consider the entire conversion chain:

Energy input → energy available in the phenomenon → converted energy → electrical energy

The objective is not to circumvent the laws of thermodynamics, but to determine whether a different conversion architecture can avoid the use of an intermediate thermodynamic cycle and what performance it can achieve.

TEAS®–L-CPC

Not a more efficient heat engine.

A different conversion architecture.

From Heat to the Phenomenon.

TEAS®–L-CPC is a research and development project. The phenomenon, the energy that can actually be converted, and the performance of the architecture are subject to experimental validation.